I can't for the life of me find where now, but sometime in early December, I saw an image of a leather skirt. With a sequin border. And it was gorgeous. And somewhere in the range of super pricey to astronomical.
Shirt: J.Crew Factory; Skirt: thrifted with the sequin border added by me (fabric from fabric.com); Sweater tights: Target; Sandals: Old Navy; Necklace: Ann Taylor Factory (similar); Purse: Etsy
I remembered I had a black suede leather skirt languishing in my closet. I liked it, but for some reason, just didn't get to it that often. I thought it would be perfect for a little upcycling with some sequin fabric I had on hand (mine was from fabric.com, but sadly, it doesn't seem they have it any more).
Wanna do it yourself? Here's how!
DIY Sequin Border Skirt
1. Measure the width of your skirt at the bottom (I used a pencil skirt for ease so it was the same at the top and bottom of the border). Double that number and add 3-4" to wrap the ends around the vent. Determine how tall you want your border (mine was about 3 or 4") and add 1" to that measurement. Cut your sequin fabric to the appropriate height and width.
2. Because my skirt was suede leather and was very thick, my pins wouldn't go through. Instead, I folded the top over twice so it wouldn't fray and stuck it to my skirt with painters tape. (If your skirt is a thinner fabric, feel free to use pins instead). Then, wrap the fabric all the way around the bottom of the skirt and up and under to the inside. Fold over twice again and stick or pin in place.
3. Wrap the edges (the short sides) around the back vent so they fold around to the inside of the skirt.
4. Sew (using a heavy duty needle if you have a thick fabric like mine!) with matching thread 1/4-1/2" from the edge (you want to be close to the edge, but you want to make sure you're catching all the layers where you folded so it wouldn't fray) on both the top and the bottom, pulling off tape or pins as you go.
Linking up with the winthrop chronicles